Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location PL
Mob_nav_barsMENU

HP Exam HPE6-A85 Topic 6 Question 41 Discussion

Actual exam question for HP's HPE6-A85 exam
Question #: 41
Topic #: 6
[All HPE6-A85 Questions]

Which commands are used to set a default route to 10.4.5.1 on an Aruba CX switch when ln-band management using an SVl is being used?

Show Suggested Answer Hide Answer
Suggested Answer: C

The command that is used to set a default route to 10.4.5.1 on an Aruba CX switch when in-band management using an SVI is being used is ip route 0.0 0 0/0 10.4.5.1 . This command specifies the destination network address (0.0 0 0) and prefix length (/0) and the next-hop address (10.4.5.1) for reaching any network that is not directly connected to the switch. The default route applies to the default VRF Virtual Routing and Forwarding. VRF is a technology that allows multiple instances of a routing table to co-exist within the same router at the same time. VRFs are typically used to segment network traffic for security, privacy, or administrative purposes. , which is used for in-band management traffic that goes through an SVI Switch Virtual Interface. SVI is a virtual interface on a switch that allows the switch to route packets between different VLANs on the same switch or different switches that are connected by a trunk link.An SVI is associated with a VLAN and has an IP address and subnet mask assigned to it12. Reference:1https://www.arubanetworks.com/techdocs/AOS-CX/10_08/HTML/ip_route_4100i-6000-6100-6200/Content/Chp_StatRoute/def-rou.htm2https://www.arubanetworks.com/techdocs/AOS-CX/10_08/HTML/ip_route_4100i-6000-6100-6200/Content/Chp_VRF/vrf-overview.htm


by Kelvin at Apr 07, 2025, 04:12 PM

Limited Time Offer

25%

Off

Get Premium HPE6-A85 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel
Karl
2 days ago
B looks good to me. Specifying the VRF for management seems like the right approach.
upvoted 0 times
...
Mozell
5 days ago
I see your point, but I still think A) makes more sense because it's a simpler command
upvoted 0 times
...
An
8 days ago
I think the correct answer is A. It's a straightforward command to set the default gateway.
upvoted 0 times
...
Felicidad
10 days ago
I disagree, I believe the correct answer is B) ip route 0 0 0.0 10.4.5.1 vrf mgmt
upvoted 0 times
...
Mozell
12 days ago
I think the answer is A) ip default-gateway 10.4.5.1
upvoted 0 times
...

Save Cancel
az-700  pass4success  az-104  200-301  200-201  cissp  350-401  350-201  350-501  350-601  350-801  350-901  az-720  az-305  pl-300  

Warning: Cannot modify header information - headers already sent by (output started at /pass.php:70) in /pass.php on line 77