A network technician at a branch office is connecting VolP phones to a newly configured AOS-CX switch. Users are complaining that voice quality is not as good as at the corporate office. Further investigation
shows the local-priority value at the branch office is 1 while at the corporate office is 5.
What describes the issue regarding the default QoS behavior on the AOS-CX switch?
In an AOS-CX switch, if the QoS trust mode is not configured, it is set to none by default. The VoIP phones will mark their traffic with a local-priority value, which, if the QoS trust mode is none, will correspond to CoS map entry 1 by default. The local-priority value of 1 at the branch office likely indicates that the traffic is not being prioritized correctly compared to the corporate office, where a local-priority of 5 suggests a higher level of prioritization for voice traffic.
What are two characteristics of ClientMatch? (Select two.)
ClientMatch is an Aruba patented technology that helps to move sticky clients---clients that stay connected to an AP even when there are better APs available---to a more appropriate AP. This technology ensures that clients are always connected to the best available AP, optimizing both the client's performance and the overall performance of the wireless network.
Based on the "show ip route" output on an Aruba CX 8325, what type of route is "10.20.0.0/22, vrf default via 10.1.1.1, [110/200]"?
The route '10.20.0.0/22, vrf default via 10.1.1.1, [110/200]' indicates that it is an OSPF route. This is evidenced by the administrative distance and metric '[110/200]' where 110 is the default administrative distance for OSPF routes.
What are two characteristics of ClientMatch? (Select two.)
ClientMatch is an Aruba patented technology that helps to move sticky clients---clients that stay connected to an AP even when there are better APs available---to a more appropriate AP. This technology ensures that clients are always connected to the best available AP, optimizing both the client's performance and the overall performance of the wireless network.
After having configured the edge switch uplink as requested your colleague says that they have failed to ping the core You ask your colleague to verify the connection is plugged in and the switch is powered on They confirm that both are correct You attempt to ping the core switch and confirm that the ping is failing.
Knowing the nature of this deployment, what commands might you use to troubleshoot this issued
Currently there are no comments in this discussion, be the first to comment!