NetApp Exam NS0-184 Topic 7 Question 45 Discussion

Actual exam question for NetApp's NS0-184 exam

Question #: 45
Topic #: 7

[All NS0-184 Questions]

After the installation of a new ONTAP 9.8 cluster, you have to verify if AutoSupport works.

In this scenario, which two commands would you use to accomplish this task? (Choose two.)

Asystem node autosupport history show

Bsystem node autosupport check show

Csystem node autosupport destination show

Dsystem node autosupport invoke

Show Suggested Answer

Suggested Answer: B, D

by Lavonda at May 13, 2024, 06:47 AM

Limited Time Offer

25%

Off

Get Premium NS0-184 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel

Stevie

10 days ago

I'm not sure about the commands, but I know AutoSupport is important for monitoring the health of the cluster.

upvoted 0 times

...

Cassi

11 days ago

I'm going with B and C. Showing the destinations and checking the status seems like the straightforward way to verify AutoSupport is set up correctly.

upvoted 0 times

...

Tiera

12 days ago

Ha! I bet the correct answer involves some combination of 'show' and 'invoke' commands. That's how they always get you in these tests.

upvoted 0 times

...

Estrella

15 days ago

I agree with Carman. I would also use C) system node autosupport destination show to verify AutoSupport settings.

upvoted 0 times

...

Carman

16 days ago

I think I would use A) system node autosupport history show to check AutoSupport.

upvoted 0 times

...

Leonie

17 days ago

Hmm, I'm not sure about D. Isn't that for triggering a manual AutoSupport upload? I think A and C are better for just verifying the setup.

upvoted 0 times

...

Ilda

18 days ago

I think B and D are the correct commands. We need to check the AutoSupport configuration and then manually invoke it to verify it's working.

upvoted 0 times

...