Juniper Exam JN0-363 Topic 16 Question 24 Discussion

Actual exam question for Juniper's JN0-363 exam

Question #: 24
Topic #: 16

Exhibit

You want the R1 and R3 routers to forward traffic destined to the 203.0.113.0/24 network through R2. Which BGP attribute would you modify to satisfy this requirement?

Acommunity

Borigin

CMED

Dlocal preference

Show Suggested Answer

Suggested Answer: C

https://www.cisco.com/c/en/us/support/docs/ip/open-shortest-path-first-ospf/13684-12.html#anc13

Neighbors Stuck in Exstart/Exchange State The problem occurs most frequently when you attempt to run OSPF between a Cisco router and another vendor router. The problem occurs when the maximum transmission unit (MTU) settings for neighboring router interfaces do not match. If the router with the higher MTU sends a packet larger that the MTU set on the neighboring router, the neighbor router ignores the packet. When this problem occurs, the output of the show ip ospf neighbor command displays output similar to what is shown in this figure.

by Becky at Dec 21, 2023, 10:19 PM

Limited Time Offer

25%

Off

Get Premium JN0-363 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel

Felix

5 days ago

I think the correct answer is D) local preference. Modifying the local preference attribute would make the R1 and R3 routers prefer the route through R2 over any other available routes.

upvoted 0 times

...