HP Exam HPE7-A07 Topic 1 Question 8 Discussion

Actual exam question for HP's HPE7-A07 exam

Question #: 8
Topic #: 1

Exhibit.

After configuring VRRP between sw-1 and SW-2. you notice that both switches are showing as active. What could be the reason for this issue?

AVRRP preemptive mode is disabled.

BSW-1 cam reach SW-2 on VLAN 10.

CBoth switches are configured as VRRP 'primary.'

DSW-2 has no priority configurations for VRRP 1.

Show Suggested Answer

Suggested Answer: C

In VRRP (Virtual Router Redundancy Protocol), only one switch should be the primary (master) for a given virtual IP address, with the other switches being backups. If both switches are showing as active, it suggests a misconfiguration where both are set to act as the primary for the same VRRP group. The exhibits provided indicate that both switches believe they are the active or primary for the VRRP group, which is an incorrect configuration.

by Cristina at Apr 19, 2024, 12:17 PM

Limited Time Offer

25%

16 days ago

I think the reason could be VRRP preemptive mode is disabled.

upvoted 0 times

...