Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location PL
Mob_nav_barsMENU

HP Exam HPE7-A01 Topic 8 Question 15 Discussion

Actual exam question for HP's HPE7-A01 exam
Question #: 15
Topic #: 8
[All HPE7-A01 Questions]

With the Aruba CX switch configuration, what is the Active Gateway feature that is used for and is unique to VSX configuration?

Show Suggested Answer Hide Answer
Suggested Answer: A

Active gateway is a first hop redundancy protocol that eliminates a single point of failure. The active gateway feature is used to increase the availability of the default gateway servicing hosts on the same subnet. An active gateway improves the reliability and performance of the host network by enabling a virtual router to act as the default gateway for that network.If you have enabled active gateway, VRRP is not required3. Active gateway is similar to VRRP in that routed traffic from the VSX node is sourced from the switch interface MAC and not the virtual MAC address (VMAC). Each active gateway sends a periodic broadcast hello packet to avoid VMAC aging on the access switches.The switch views the active gateway IP as a self IP address3.Active gateway is preferable over VRRP because with VRRP traffic is still pushed over the ISL link, resulting in latency in the network3. Therefore, VRRP and active gateway are mutually exclusive on a VLAN, and answer A is correct.


by Shad at Apr 25, 2024, 07:53 PM

Limited Time Offer

25%

Off

Get Premium HPE7-A01 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel
Lashonda
10 hours ago
I think it's used for optimizing the path over the ISL link.
upvoted 0 times
...
Darrin
1 days ago
What is the Active Gateway feature used for in Aruba CX switch configuration?
upvoted 0 times
...
Portia
9 days ago
Yes, sixteen different VMACs are supported for each IPV4 and IPV6 stack simultaneously.
upvoted 0 times
...
Daren
10 days ago
Is there support for each IPV4 and IPV6 stack simultaneously?
upvoted 0 times
...
Tashia
11 days ago
Sixteen different VMACs are supported as shared.
upvoted 0 times
...
Golda
12 days ago
How many different VMACs are supported total in this configuration?
upvoted 0 times
...
Portia
13 days ago
Yes, it is unique to VSX configuration.
upvoted 0 times
...
Daren
14 days ago
Is Active Gateway unique to VSX configuration?
upvoted 0 times
...
Tashia
15 days ago
Active Gateway can optimize path copying over the ISL link.
upvoted 0 times
...
Golda
16 days ago
What is the Active Gateway feature used for in Aruba CX switch configuration?
upvoted 0 times
...

Save Cancel
az-700  pass4success  az-104  200-301  200-201  cissp  350-401  350-201  350-501  350-601  350-801  350-901  az-720  az-305  pl-300  

Warning: Cannot modify header information - headers already sent by (output started at /pass.php:70) in /pass.php on line 77