HP Exam HPE0-S59 Topic 6 Question 32 Discussion

Actual exam question for HP's HPE0-S59 exam

Question #: 32
Topic #: 6

Your customer plans to use HPE Primera to boot HPE Synergy compute nodes. They currently have two HPE Virtual Connect SE 100Gb F32 Module for Synergy modules installed in the frame. The customer wants to use FC as a storage access protocol

What must be done to complete this task?

AEnable FC primary and secondary boot on the modules through the HPE OneView interface

BFC connectivity on the modules should be enabled through the service console by disabling FCoE.

CAdd FC upgrade licenses in HPE OneView that will enable FC connectivity for the modules

DEnter both modules into a maintenance mode, then enable FC connectivity through CLI

Show Suggested Answer

Suggested Answer: B

by Leslie at Apr 08, 2024, 06:08 AM

Limited Time Offer

25%

Off

Get Premium HPE0-S59 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel

Cordelia

10 days ago

I agree with Amber, option C seems like the best choice here. Adding the FC upgrade licenses in HPE OneView is probably the most straightforward and recommended way to enable FC connectivity on the existing modules.

upvoted 0 times

...

Tegan

12 days ago

Option D, 'Enter both modules into a maintenance mode, then enable FC connectivity through CLI', seems like a bit of an overkill. Why would we need to put the modules in maintenance mode just to enable FC connectivity?

upvoted 0 times

...

Aileen

13 days ago

Option B, 'FC connectivity on the modules should be enabled through the service console by disabling FCoE', seems like it might work, but I'm not sure if that's the recommended approach. Disabling FCoE could have other implications that we need to be aware of.

upvoted 0 times

...

Darell

14 days ago

Option A, 'Enable FC primary and secondary boot on the modules through the HPE OneView interface', could also work, but I'm not sure if that's the only thing that needs to be done. Enabling boot options might not be enough to fully enable FC connectivity.

upvoted 0 times

...

Amber

16 days ago

I think the correct answer is option C, 'Add FC upgrade licenses in HPE OneView that will enable FC connectivity for the modules'. This seems like the most straightforward way to enable FC connectivity on the existing modules.

upvoted 0 times

...

Dorinda

18 days ago

This is a tricky question. The customer wants to use FC as a storage access protocol, but they currently have the HPE Virtual Connect SE 100Gb F32 Module for Synergy modules installed, which are not FC-enabled by default.

upvoted 0 times

...