Cisco Exam 300-820 Topic 4 Question 74 Discussion

Actual exam question for Cisco's 300-820 exam

Question #: 74
Topic #: 4

[All 300-820 Questions]

Which step is taken when configuring a Cisco Expressway solution?

AConfigure the Expressway-E by using a non-traversal server zone.

BEnable static NAT on the Expressway-E only.

CDisable H.323 mode on the Expressway-E.

DEnable H.323 H.460.19 demultiplexing mode on the Expressway-C.

Show Suggested Answer

Suggested Answer: D

by Laticia at May 13, 2024, 10:40 AM

Limited Time Offer

25%

Off

Get Premium 300-820 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel

Melissa

3 days ago

Ooh, I think the answer is A) Configure the Expressway-E by using a non-traversal server zone. That's a pretty standard Expressway configuration step, right?

upvoted 0 times

...

Haha, I bet the answer is D) Enable H.323 H.460.19 demultiplexing mode on the Expressway-C. That sounds like the kind of obscure Cisco-specific configuration that they love to ask about in these exams!

upvoted 0 times

...

Marla

8 days ago

I'm not sure about this one. Maybe C) Disable H.323 mode on the Expressway-E? That seems like it could be a valid configuration step.

upvoted 0 times

...

Azalee

14 days ago

I believe disabling H.323 mode on the Expressway-E is also an important step to take for the configuration.

upvoted 0 times

...

Kati

16 days ago

I agree with Lauran. Enabling static NAT on the Expressway-E only doesn't seem necessary for configuring the solution.

upvoted 0 times

...

Lauran

17 days ago

I think the correct step is to configure the Expressway-E by using a non-traversal server zone.

upvoted 0 times

...

Pearly

18 days ago

I think the correct answer is B) Enable static NAT on the Expressway-E only. This is a common configuration step to ensure that external clients can connect to the Expressway-E properly.

upvoted 0 times

Shakira

1 days ago

I think the correct answer is B) Enable static NAT on the Expressway-E only.

upvoted 0 times

...

Shalon

18 days ago

I believe disabling H.323 mode on the Expressway-E is also an important step to take for the configuration.

upvoted 0 times

...

Corrie

22 days ago

I agree with Dierdre. Enabling static NAT on the Expressway-E only doesn't seem necessary for configuring the solution.

upvoted 0 times

...

Dierdre

26 days ago

I think the correct step is to configure the Expressway-E by using a non-traversal server zone.

upvoted 0 times

...

Cisco Exam 300-820 Topic 4 Question 74 Discussion

Contribute your Thoughts:

Melissa

Wava

Marla

Azalee

Kati

Lauran

Pearly

Shakira

Shalon

Corrie

Dierdre