Cisco Exam 300-715 Topic 11 Question 71 Discussion

Actual exam question for Cisco's 300-715 exam

Question #: 71
Topic #: 11

Refer to the exhibit. An engineer is creating a new TACACS* command set and cannot use any show commands after togging into the device with this command set authorization Which configuration is causing this issue?

AQuestion marks are not allowed as wildcards for command sets.

BThe command set is allowing all commands that are not in the command list

CThe wildcard command listed is in the wrong format

DThe command set is working like an ACL and denying every command.

Show Suggested Answer

Suggested Answer: D

https://www.cisco.com/c/en/us/td/docs/security/ise/2-4/admin_guide/b_ISE_admin_guide_24/m_ise_tacacs_device_admin.html

by Glendora at Jul 07, 2023, 03:26 AM

Limited Time Offer

25%

Off

Get Premium 300-715 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel

Daryl

4 days ago

Haha, the engineer should have used the 'show me' command instead of 'show' - that would have worked for sure!

upvoted 0 times

...

Dortha

13 days ago

I'm going with option C. The wildcard command listed is probably in the wrong format, preventing the show commands from working.

upvoted 0 times

...

Catherin

14 days ago

But what about option B? Allowing all commands not in the list could also be causing the problem.

upvoted 0 times

...

Yuriko

16 days ago

I agree with Viki. If the command set is denying every command, that would explain why show commands are not working.

upvoted 0 times

...

Jaclyn

22 days ago

Option B seems more likely to me. The command set is allowing all commands that are not in the command list, which would explain why the show commands are not working.

upvoted 0 times

Loren

2 days ago

User 1: I think option B is the issue.

upvoted 0 times

...

Viki

22 days ago

I think the issue might be with option D. The command set is denying every command.

upvoted 0 times

...

Hobert

23 days ago

I'm not sure, but I think option C could also be a potential issue. The wildcard command format might be incorrect.

upvoted 0 times

...

Felicitas

23 days ago

I think option D is the correct answer. The command set is working like an ACL and denying every command, so the engineer can't use any show commands after logging in with this authorization.

upvoted 0 times

...

Rosalyn

24 days ago

I agree with An. Option D seems to be the most likely cause of the problem.

upvoted 0 times

...

An

1 months ago

I think the issue is with option D. The command set is denying every command.

upvoted 0 times

...