Cisco Exam 300-710 Topic 3 Question 71 Discussion

Actual exam question for Cisco's 300-710 exam

Question #: 71
Topic #: 3

An organization is installing a new Cisco FTD appliance in the network. An engineer is tasked with configuring access between two network segments within the same IP subnet. Which step is needed to accomplish this task?

AAssign an IP address to the Bridge Virtual Interface.

BPermit BPDU packets to prevent loops.

CSpecify a name for the bridge group.

DAdd a separate bridge group for each segment.

Show Suggested Answer

Suggested Answer: A

by Marvel at Jul 30, 2023, 09:43 AM

Limited Time Offer

25%

Off

Get Premium 300-710 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel

Dannie

14 hours ago

I'm just hoping the question doesn't involve any bridge trolls. That would really throw a wrench in the works!

upvoted 0 times

...

Ernest

4 days ago

I'm going with C. Specifying a name for the bridge group seems like a reasonable step in the configuration process.

upvoted 0 times

...

Avery

9 days ago

B is the answer! Permitting BPDU packets is crucial to prevent loops in the network, which is a common issue when configuring bridging.

upvoted 0 times

...

Annamae

12 days ago

Option D sounds like the right choice to me. Creating a separate bridge group for each segment would allow for independent configuration and management.

upvoted 0 times

...

Anissa

13 days ago

I'm not sure, but I think C) Specify a name for the bridge group could also be a valid option.

upvoted 0 times

...

Loren

14 days ago

I disagree, I believe the correct answer is A) Assign an IP address to the Bridge Virtual Interface.

upvoted 0 times

...

Ngoc

14 days ago

I think option A is the correct answer. Assigning an IP address to the Bridge Virtual Interface is necessary to enable communication between the two network segments.

upvoted 0 times