Cisco Exam 300-615 Topic 5 Question 109 Discussion

Actual exam question for Cisco's 300-615 exam

Question #: 109
Topic #: 5

Refer to the exhibit.

The EEM script is applied in the default VDC to collect the outputs during high CPU utilization on the Cisco Nexus 7000 Series Switch for all VDCs. Which configuration set must be added to the script to fix the issue?

Aswitch(config-apple)# event snmp 1.3.6.1.4.1.9.9.109.1.1.1.1.6.1 get-type exact entry-op ge entry-val 50 poll-interval 1
switch(config-apple)# action 0.2 cli enable
switch(config-apple)# action 0.5 cli switchto vdc Core
switch(config-apple)# action 0.8 cli switchto vdc Distribution

Bswitch(config-apple)# event snmp oid 1.3.6.1.4.1.9.9.109.1.1.1.1.6.1 get-type exact entry-op ge entry-val 50 poll-interval 1
switch(config-apple)# action 0.2 cli enable
switch(config-apple)# action 0.5 cli switchto vdc Core
switch(config-apple)# action 0.8 cli switchto vdc Distribution

Cswitch(config-apple)# event snmp oid 1.3.6.1.4.1.9.9.109.1.1.1.1.6.1 get-type exact entry-op ge entry-val 50 poll-interval 1
switch(config-apple)# action 0.2 cli config t
switch(config-apple)# action 0.5 cli switchto vdc Core
switch(config-apple)# action 0.8 cli switchto vdc Distribution

Dswitch(config-apple)# event snmp 1.3.6.1.4.1.9.9.109.1.1.1.1.6.1 get-type exact entry-op ge entry-val 50 poll-interval 1
switch(config-apple)# action 0.2 cli config t
switch(config-apple)# action 0.5 cli switchto vdc Core
switch(config-apple)# action 0.8 cli switchto vdc Distribution

Show Suggested Answer

Suggested Answer: B

Need exact snap shot to confirm the following.

The selection of is due to

SNMP command has the key word ''oid''.

The command ''switchto vdc Core'' show run in ''enable'' mode, not ''config t'' mode.

by Dusti at Apr 05, 2025, 03:05 AM

Limited Time Offer

25%

Off

Get Premium 300-615 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel

Shenika

5 days ago

Hmm, you might be right. Including 'config t' could be important for fixing the issue.

upvoted 0 times

...

Rodney

6 days ago

I disagree, I believe option D is the right one because it includes the necessary 'config t' command.

upvoted 0 times

...

Nakita

8 days ago

The correct answer is C. The configuration set uses the 'event snmp oid' command to monitor the SNMP OID, and the 'action' commands to switch to the Core and Distribution VDCs.

upvoted 0 times

...

Shenika

27 days ago

I think the correct configuration set is option A.

upvoted 0 times

...