Cisco Exam 300-435 Topic 7 Question 57 Discussion

Actual exam question for Cisco's 300-435 exam

Question #: 57
Topic #: 7

[All 300-435 Questions]

Refer to the exhibit.

The configuration commands are entered in CLI config mode to configure a static telemetry

subscription on a Cisco IOS XE device. The commands are accepted by the device, but the consumer receives

no telemetry dat

a. Which change must be made to ensure that the consumer receives the telemetry data?

AThe IP address of the receiver must be set.

BThe stream type must be set to YANG.

CThe update policy period must be shortened.

DThe sender IP address must be set.

Show Suggested Answer

Suggested Answer: A

b_1610_programmability_cg/model_driven_telemetry.html

by Bernardo at Jan 23, 2024, 08:48 PM

Limited Time Offer

25%

Off

Get Premium 300-435 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel

Alline

1 years ago

Wait, wait, wait. Are we sure the consumer is set up correctly? Maybe the IP address of the receiver needs to be specified. That's a pretty common gotcha in these kinds of configs.

upvoted 0 times

Iola

1 years ago

Okay, let's give it a shot and check if the consumer receives the telemetry data after this change.

upvoted 0 times

...

Rochell

1 years ago

Let's try setting the stream type to YANG to see if that helps.

upvoted 0 times

...

Milly

1 years ago

B) The stream type must be set to YANG.

upvoted 0 times

...

Argelia

1 years ago

Should we check and configure the receiver IP address to see if that resolves the issue?

upvoted 0 times

...

Melda

1 years ago

Yes, that's a possibility. It could be the reason why no telemetry data is reaching the consumer.

upvoted 0 times

...

Colette

1 years ago

Wait, are you saying the receiver IP address is missing?

upvoted 0 times

...

Colby

1 years ago

A) The IP address of the receiver must be set.

upvoted 0 times

...

Haha, classic networking exam question. I bet the answer is something simple like the update policy period. You know how these vendors love to hide the solution in the details. I'd try shortening that period and see if it does the trick.

upvoted 0 times

...

Billye

1 years ago

Good point. The question does say the commands were accepted by the device, but maybe there's a mismatch between what the device is sending and what the consumer is expecting. I'd double-check the receiver settings too.

upvoted 0 times

...

Desiree

1 years ago

I'm not sure why the telemetry data isn't being received. The configuration commands look correct to me. Maybe there's an issue with the network or the consumer's setup.

upvoted 0 times

...

Cisco Exam 300-435 Topic 7 Question 57 Discussion

Contribute your Thoughts:

Alline

Iola

Rochell

Milly

Argelia

Melda

Colette

Colby

Isreal

Billye

Desiree