Free Cisco 300-410 Exam Dumps

MultipleChoice

Refer to the exhibit.

The network administrator configured the branch router for IPv6 on the E 0/0 interface The neighboring router is fully configured to meet requirements, but the neighbor relationship is not coming up. Which action fixes the problem on the branch router to bring the IPv6 neighbors up?

MultipleChoice

Refer to the exhibit.

An engineer receives this error message when trying to access another router m-band from the serial interface connected to the console of R1. Which configuration is needed on R1 to resolve this issue?

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. an engineer is trying to get 192.168.32.100 forwarded through 10.1.1.1, but it was forwarded through 10.1.1.2. What action forwards the packets through 10.1.1.1?

MultipleChoice

A network engineer must configure a DMVPN network so that a spoke establishes a direct path to another spoke if the two must send traffic to each other. A spoke must send traffic directly to the hub if required. Which configuration meets this requirement?

A)

B)

C)

D)

MultipleChoice

Refer to the exhibit.

R3 cannot authenticate via TACACS. Which configuration resolves the issue?

A)

B)

C)

D)

MultipleChoice

The summary route is not shown in the Router_B routing table after this below configuration on Router_A:

Which Router_A configuration resolves the issue by advertising the summary route to Route_B?

A)

B)

C)

MultipleChoice

Refer to the exhibit.

The administrator configured the network devices for end reachability, but the ASBRs are not propagating routes to each other. Which set of configuration resolved this issue?

A)

B)

C)

D)

MultipleChoice

Exhibit.

A network is configured for EIGR equal-cost balancing, but the traffic destined to the servers is not load balance. .....resolve the issue?

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. An engineer has successfully set up a floating static route from the BRANCH router to the HQ network using HQ_R1 as the primary default gateway When the g0/0 goes down on HQ_R1, the branch network cannot reach the HQ network 192.168.20.0/24. Which set of configurations resolves the issue?

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. The network administrator configured the branch router for IPv6 on the E 0/0 interface The neighboring router is fully configured to meet requirements, but the neighbor relationship is not coming up. Which action fixes the problem on the branch router to bring the IPv6 neighbors up?