CheckPoint Exam 156-586 Topic 1 Question 29 Discussion

Actual exam question for CheckPoint's 156-586 exam

Question #: 29
Topic #: 1

The Check Point Firewall Kernel is the core component of the Gaia operating system and an integral part of the traffic inspection process. There are two procedures available for debugging the firewall kernel. Which procedure/command is used for troubleshooting packet drops and other kernel activities while using minimal resources (1 MB buffer)?

Afw debug ctl

Bfw ctl debug/kdebug

Cfw ctl zdebug

Dfwk ctl debug

Show Suggested Answer

Suggested Answer: C

by Patrick at Sep 19, 2024, 02:42 PM

Limited Time Offer

25%

Off

Get Premium 156-586 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel

Yong

1 months ago

Whoa, this question is like a firewall kernel trap! Better not fw ctl my keyboard too hard, or I might end up in the debug logs.

upvoted 0 times

...

Jacquelyne

1 months ago

Easy peasy, the answer is A, fw debug ctl. No doubt about it. It's the one that uses the least resources, so it's got to be the winner here.

upvoted 0 times

Scarlet

12 days ago

I agree, A) fw debug ctl seems like the best option for minimal resource usage.

upvoted 0 times

...

Sol

14 days ago

I'm not sure, but I think C) fw ctl zdebug might also be a good choice for debugging kernel activities.

upvoted 0 times

...

Roxane

17 days ago

I think it's A) fw debug ctl too, it's the most efficient option for troubleshooting.

upvoted 0 times

...

Lynda

1 months ago

I'm going with D, fwk ctl debug. It just sounds like the right command, you know? Plus, I've used it before on a similar issue. Gotta trust your gut, am I right?

upvoted 0 times

Tyra

23 days ago

User 3: I'm not sure, but I think B, fw ctl debug/kdebug, might be the one. I've heard good things about it for debugging kernel activities.

upvoted 0 times

...

Ashton

28 days ago

User 2: I'm going with D, fwk ctl debug. It just sounds like the right command, you know? Plus, I've used it before on a similar issue. Gotta trust your gut, am I right?

upvoted 0 times

...

Shawana

30 days ago

User 1: I think it's C, fw ctl zdebug. That's the one I usually use for troubleshooting packet drops.

upvoted 0 times

...

Gladis

2 months ago

Hmm, I wasn't too sure about this one. But after reading the question again, I think C, fw ctl zdebug, is the correct answer. It's a low-resource option, right?

upvoted 0 times

Merlyn

11 days ago

Yes, fw ctl zdebug is the command used for troubleshooting packet drops and kernel activities with minimal resources.

upvoted 0 times

...

Rolande

15 days ago

I agree, fw ctl zdebug is the correct option for troubleshooting with minimal resources.

upvoted 0 times

...

Michel

1 months ago

I think the answer is C, fw ctl zdebug.

upvoted 0 times

...

Myrtie

2 months ago

Ah, I remember this one! The answer has to be B, fw ctl debug/kdebug. That's the command that allows you to troubleshoot packet drops and other kernel activities while keeping resource usage to a minimum.

upvoted 0 times